Black & Decker Electric Hedge Trimmer Sparked and Won’t Start?

1. Loose or damaged spark plug

The spark plug is not making a good connection with the engine, which is preventing it from starting.
Check the spark plug for damage and make sure it is properly tightened.

2. Faulty spark plug wire

The spark plug wire is not transferring the spark from the spark plug to the engine, which is preventing it from starting.
Check the spark plug wire for damage and make sure it is properly connected to the spark plug and the engine.

3. Clogged carburetor

The carburetor is not providing the engine with the proper fuel mixture, which is preventing it from starting.
Clean the carburetor according to the manufacturer’s instructions.

4. Bad fuel

The fuel is contaminated or old, which is preventing it from burning properly in the engine.
Use fresh, clean fuel.

5. Flooded engine

The engine is flooded with fuel, which is preventing it from starting.
Turn the engine off and let it sit for a few minutes. Then, try starting it again.

6. Compression problem

The engine is not creating enough compression, which is preventing it from starting.
This could be caused by a number of problems, such as a blown head gasket, a cracked piston, or worn-out valves.
Have the engine inspected by a qualified technician.

Black And Decker Electric Hedge Trimmer Sparked Won’T Start

1. Faulty spark plug

The spark plug may be damaged or dirty, preventing it from creating a spark.
To check the spark plug, remove it from the engine and inspect it for damage. If the spark plug is damaged, replace it with a new one. If the spark plug is dirty, clean it with a wire brush and reattach it to the engine.

2. Faulty spark plug wire

The spark plug wire may be damaged or disconnected, preventing the spark from reaching the spark plug.
To check the spark plug wire, inspect it for damage or signs of corrosion. If the spark plug wire is damaged, replace it with a new one. If the spark plug wire is disconnected, reconnect it to the spark plug.

3. Faulty ignition switch

The ignition switch may be damaged or stuck in the off position, preventing the engine from starting.
To check the ignition switch, turn the key to the on position and listen for a click. If you do not hear a click, the ignition switch may be damaged. Replace the ignition switch with a new one.

4. Faulty starter solenoid

The starter solenoid may be damaged or stuck in the engaged position, preventing the starter from engaging.
To check the starter solenoid, turn the key to the start position and listen for a click. If you do not hear a click, the starter solenoid may be damaged. Replace the starter solenoid with a new one.

5. Low battery voltage

The battery may be low on voltage, preventing the engine from starting.
To check the battery voltage, use a voltmeter to measure the voltage at the battery terminals. If the battery voltage is below 12 volts, charge the battery or replace it with a new one.

How to Troubleshoot And Fix: Black and Decker Electric Hedge Trimmer Sparked Won’t Start

Symptoms

Your Black and Decker electric hedge trimmer won’t start.
The trimmer sparks when you try to start it.
The trimmer makes a humming noise when you try to start it.

Causes

There are a few possible causes for a Black and Decker electric hedge trimmer that sparks but won’t start.

The battery is dead:
If the battery is dead, the trimmer won’t have enough power to start. Try charging the battery for a few hours and then try starting the trimmer again.

The battery terminals are corroded:
If the battery terminals are corroded, they can prevent the battery from making a good connection with the trimmer. Clean the battery terminals with a wire brush and then try starting the trimmer again.

The spark plug is bad:
If the spark plug is bad, it won’t be able to create a spark to ignite the fuel. Check the spark plug and replace it if it is damaged or worn out.

The fuel line is clogged:
If the fuel line is clogged, it can prevent the fuel from reaching the engine. Clean the fuel line and then try starting the trimmer again.

The carburetor is dirty:
If the carburetor is dirty, it can prevent the engine from getting the correct mixture of air and fuel. Clean the carburetor and then try starting the trimmer again.

Troubleshooting

To troubleshoot a Black and Decker electric hedge trimmer that sparks but won’t start, follow these steps:

1. Check the battery. Make sure that the battery is charged and that the battery terminals are clean.
2. Check the spark plug. Remove the spark plug and check it for damage or wear. If the spark plug is damaged or worn out, replace it.
3. Check the fuel line. Make sure that the fuel line is clear and free of obstructions.
4. Check the carburetor. Clean the carburetor according to the manufacturer’s instructions.

If you have checked all of these things and the trimmer still won’t start, you may need to take it to a qualified repair technician.

Prevention

To prevent your Black and Decker electric hedge trimmer from sparking but not starting, follow these tips:

Keep the battery charged.
Clean the battery terminals regularly.
Replace the spark plug regularly.
Clean the fuel line regularly.
Clean the carburetor regularly.

By following these tips, you can help to keep your Black and Decker electric hedge trimmer running smoothly and efficiently.

Also Read: Black And Decker Electric Hedge Trimmer Won T Start

Similar Posts

Leave a Reply

Your email address will not be published. Required fields are marked *