Excell Pressure Washer Pump Not Working: [Fixed]

As a Pressure Washer Repair Technician, I have seen firsthand the frustration and inconvenience that can come from a pressure washer pump not working. Not only is it a major inconvenience, but it can also be dangerous if the pressure washer is not properly maintained.

That’s why I’ve put together this troubleshooting guide to help you quickly diagnose and resolve the issue. By following these steps, you can get your pressure washer up and running again in no time.

Here are the key takeaways:

A pressure washer pump not working can be caused by a number of issues, including a clogged filter, a faulty pressure switch, or a broken pump.
To troubleshoot the problem, you’ll need to first identify the symptoms and then perform a series of checks and tests.
Once you’ve identified the cause of the problem, you can then repair or replace the faulty component and get your pressure washer back up and running.

Most Common Reasons Excell Pressure Washer Pump Not Working

Most Common Reasons

1. No Water Flow

Cause:
The most common reason for no water flow is a clogged filter. To check the filter, remove it from the pump and clean it with a brush. If the filter is clogged, replace it with a new one.

Solution:
To fix this problem, clean or replace the filter.

2. Low Water Pressure

Cause:
Low water pressure can be caused by a number of factors, including:

A clogged nozzle:
To check the nozzle, remove it from the gun and clean it with a brush. If the nozzle is clogged, replace it with a new one.

A kinked hose:
Check the hose for kinks or leaks. If the hose is kinked, straighten it out or replace it with a new one.

A dirty pump:
To clean the pump, remove the inlet and outlet hoses and flush the pump with water.

A faulty pressure switch:
To check the pressure switch, disconnect the wires from the switch and test it with a multimeter. If the pressure switch is faulty, replace it with a new one.

Solution:
To fix this problem, clean or replace the nozzle, straighten out or replace the hose, clean the pump, or replace the pressure switch.

3. The Pump Won’t Start

Cause:
The pump won’t start if there is no power to the pump. To check the power, make sure that the power cord is plugged into an outlet and that the outlet is turned on.

Solution:
To fix this problem, make sure that the power cord is plugged into an outlet and that the outlet is turned on.

4. The Pump Is Overheating

Cause:
The pump can overheat if it is used for too long or if the water temperature is too high. To prevent the pump from overheating, take frequent breaks when using the pressure washer and do not use it on hot water.

Solution:
To fix this problem, let the pump cool down before using it again. Do not use the pressure washer on hot water.

#ERROR!

Also Read: Generac Pressure Washer Soap Dispenser Not Working

Similar Posts

Leave a Reply

Your email address will not be published. Required fields are marked *