How To Put Screw In Power Drill: [Explained]

Power Drills: A Screwdriver’s Best Friend

Power drills are a versatile tool that can be used for a variety of tasks, from drilling holes to driving screws. But how do you put a screw in with a power drill It’s actually quite simple, and we’ll show you how in this brief guide.

First, make sure that the drill bit you’re using is the correct size for the screw. Then, hold the drill in your dominant hand and the screw in your other hand. Insert the tip of the drill bit into the head of the screw and turn on the drill. The drill will drive the screw into the material.

That’s all there is to it! By following these simple steps, you can easily put screws in with a power drill.

How To Put Screw In Power Drill

To put a screw in with a power drill:
1. Insert the drill bit into the chuck.
2. Turn on the drill and set the speed to low.
3. Hold the drill steady and press the trigger to start drilling.
4. Once the screw is started, increase the speed of the drill and continue drilling until the screw is fully inserted.

Also Read: How To Remove Screws With A Power Drill

How To Put Screw In Power Drill

Step 1: Choose the right drill bit

The first step is to choose the right drill bit for the screw you are using. The size of the drill bit should be slightly smaller than the diameter of the screw shank. For example, if you are using a 6 screw, you will need a 5 drill bit.

Step 2: Mark the hole

Once you have chosen the right drill bit, you need to mark the hole where you want to put the screw. You can do this by using a center punch or by simply scratching a line with a screwdriver.

Step 3: Drill the hole

Now it is time to drill the hole. Hold the drill perpendicular to the surface and apply a little pressure. Slowly start drilling until the drill bit goes all the way through the material.

Step 4: Insert the screw

Once the hole is drilled, you can insert the screw. Hold the screw in place with one hand and turn the drill with the other hand. Continue turning the drill until the screw is flush with the surface.

Step 5: Apply a little pressure

Once the screw is in place, you can apply a little pressure to make sure it is secure. You can also use a screwdriver to turn the screw a few more times to make sure it is tight.

Tips

Always use the right drill bit for the job.

Make sure the drill is turned off before you insert the drill bit into the chuck.

Always wear safety glasses when using a power drill.

Keep the drill bit sharp to prevent it from slipping out of the screw head.